GW Instek PPX-1005

• Four current levels and two voltage levels giving you greater resolution and accuracy.
• Current Ranges & Display Resolution: 5.0000A, 500.00mA, 50.000mA & 5.0000mA. (Min resolution of 0.1µA)
• Voltage Ranges & Display Resolution: 10.000V & 1.0000V. (Min resolution of 0.1mV)
• Max output power 50W
• DC Power Supply can be set for constant voltage or constant current priority modes
• Output ON/OFF delay function.
• Adjustable voltage and current slew rate
• Bleeder circuit control
• Over-current & Over-voltage alarms can be set to protect damaging DUT.
• Sequential power output function
• Remote Sensing function to compensate for cable volt drop.
• Data Logger - Save measured voltage, current and temperature data to USB drive.
• Save Setup - 10 memory function (M1 – M10) to save set current, voltage, OCP, OVP settings.
• Supports K Type thermocouple temperature measurement
• Interfaces: USB, LAN, RS-232, RS-485, Analog Control; Opt: GPIB
• Size: 3U high, in line with 1/4 Rack

The GW Instek PPX-1005 Single Channel Programmable High-Precision DC Power Supply offers four current levels and two voltage levels giving you greater resolution and accuracy.

Current/Voltage Ranges and Display Resolution:

• 5.0000A, 500.00mA, 50.000mA & 5.0000mA.
• 10.000V & 1.0000V.
• Max Output Power of 50W.

The DC Power Supply can be set for constant voltage or constant current priority modes. You can also set voltage & current rising/falling slew rates separately and the delay time for the output to be turned on and off.

The 2.4” TFT LCD Display of the PPX Series offers four display modes. Voltage & Current or Voltage, Current & Power or Voltage, Current & Temperature or Voltage Current & Sequence Test. The PPX series can save measured voltage, current and temperature data to USB drive so measurement test records can be further analysed and compared to specification requirements. Sample rates can be set between 0.1s…999.9s.

The PPX range as been designed for testing relatively low power components and portable, wearable and IoT devices. It’s used by manufacturers/engineers who not only committed to improving the operating efficiency of the circuit, by also reducing standby power consumption as much as possible. In order to monitor very low-power measurement the units offer current measurement resolutions of 0.1μA, 1μA, 10μA & 0.1mA across four current ranges. Voltage measurement resolutions of 0.1mV & 1mV across two voltage ranges which provides the power for portable/wearable devices under test. When the device enters the sleep mode or the standby mode, the PPX series can still measure the subtle current changes of the DUT.

• 1 x Test Lead GTL-204A, 1m, 10A 
• 1 x Ground Lead GTL-201A
• Power Cord
• User Manual